JVC 3834RP0093F - Manual (Page 37)

37
REFERENCE
Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom
DVD or VCR do not
work properly.
No power.
The power is on, but
the DVD player does
not work.
No picture.
No sound.
The picture is poor.
The DVD player does
not start playback.
The remote control
does not work properly.
Video tape cannot be
inserted.
No Hi-Fi sound
Cause
DVD or VCR button is not switched
properly.
The power cord is disconnected.
No disc is inserted.
The TV is not set to receive DVD signal
output.
The video cable is not connected
securely.
The equipment connected with the
audio cable is not set to receive DVD
signal output.
The audio cables are not connected
securely.
The power of the equipment connected
with the audio cable is turned off.
The Digital Audio Output is set to the
wrong position.
The disc is dirty.
The TV channels are not tuned in properly.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The disc is dirty.
The Rating level is set.
There is an obstacle in the path of the
remote control and this unit.
The batteries in the remote control are
exhausted.
Is the cassette compartment empty?
Audio mode is not set properly.
Correction
Refer to page 2.
Plug the power cord into the wall outlet
securely.
Insert a disc. (Check that the DVD or,
audio CD indicator in the display
window is lit.)
Select the appropriate video input mode
on the TV so the picture from the DVD
player appears on the TV screen.
Connect the video cable into the jacks
securely.
Select the correct input mode of the audio
receiver so you can listen to the sound
from the DVD player.
Connect the audio cable into the jacks
securely.
Turn on the equipment connected with the
audio cable.
Set the Digital Audio Output to the
correct position, then turn on the DVD
player again by pressing POWER.
Clean the disc.
Check tuning, carry out tuning again.
Insert a playable disc. (Check the disc
type and Regional code.)
Place the disc with the playback side
down.
Place the disc on the disc tray correctly
inside the guide.
Clean the disc.
Cancel the Rating function or change the
rating level.
Remove the obstacle.
Replace the batteries with new ones.
Eject the tape in.
Select “STEREO” by repeatedly pressing
“AUDIO MONITOR” on the remote control.
Video Head Cleaning
Dirt accumulating on the head after a long period of time can cause the playback picture to become blurred or broken
up. High quality video cassette tapes will not normally deposit dirt onto the video head, but old or damaged tapes
might. Clean the video heads with a commercially available video heads cleaning tape.