Jacuzzi J - 480 - Manual (Page 59)

Page 55
J-400 Series
scan to the next higher station, play that station for a few seconds, then scan to
the next higher station. To stop scanning and continue listening to the current
station, press scan button a second time. Note: The radio remains in scan mode
until the scan button is pressed a second time or one of the tune buttons is pressed.
I. Preset Scan Function
Press the auto button (16) once to enter scan mode. The next higher preset
station will be selected and be played for 3 seconds while the preset number on
the display flashes. If you wish to remain on this station, press the auto button
(16) a second time. Note: Preset scanning continues unless you press the auto
button (16) or either preset button (P1-P6) to cancel.
J. Local/Distance Function
Press the local button (10) to toggle between local and distant station mode.
When “LOCAL” is displayed, only the strongest stations will be selected during
seek or scan. Note: In the default mode (no LOCAL display), all usable stations
will be selected during seek or scan.
K. Changing Tuner Frequency from US to Europe
Your unit is factory set to US tuning frequency steps. To switch to Europe tuning
steps, use the switch on the bottom of the unit. With the unit disconnected from
the power source, use a screwdriver to slide the switch to the desired position.
Note: Power must be removed from the radio, or the reset switch must be pressed
before the new frequency mode is activated.
19.3 CD Player Operation
A. Insert, Play, and Eject a CD
Open the front panel and insert a CD into the slot with the CD label facing
up. The CD will be drawn inside by the motorized mechanism. Close the front
panel. The “DISC IN” symbol on the display indicates that a CD is in the drive.
• To play CD: press the source button (4) to change to CD mode. The CD will
play. The display shows the current track and play time, and will animate a 3-D
rotating disc while the CD is playing. Note: If CD play time is not shown, press
clock set button (9) once.
• To remove CD: open the front panel and press the CD eject button located
under the front panel. Remove CD from drive and close front panel.
CAUTION: Listen for an audible click to ensure the front panel is
closed to prevent water intrusion that could damage your unit.