beautypg.com

Jacuzzi J - 480 User Manual

Page 40

background image

Page 36

J-400 Series

When in a Summer Logic condition is active (see note below), the filter/circula-
tion pump will turn on for all programmed filter cycles.

Summer Logic: In warm weather, the water temperature in the spa may
exceed the set temperature. This condition may occur due to heat transfer-
ence from the filter/circulation pump and jets pumps. If the water temperature
is higher than 95°F (35°C) and rises two degrees above the set temperature,
a “Summer Logic” condition occurs that deactivates the filter/circulation
pump and ozonator (if equipped). This safety feature cannot be altered! The
filter/circulation pump and ozonator will remain off until the water tempera-
ture cools to the set temperature (except between

9:00 - 11:00 AM

when the

filter/circulation pump runs for its mandatory 2-hour cycle). To help prevent
a “Summer Logic” condition, it may be necessary to reduce filter/circulation
pump cycles run times in warm weather.

To make adjustments, first press the CYCLE

button to enter the filter cycle

programming mode. The LCD screen will display the following in the upper
right corner:

1*

This means the system is ready to accept your changes to the start time for cycle
number one. Simultaneously, the large four-digit display in the center of the
screen displays the currently programmed start time for that cycle. At this point,
you have four options. You may:

1. Press WARMER

or COOLER

button to adjust the start time in

increments of 30 minutes.

2. Press CYCLE

button to display and adjust each subsequent cycles start

time. With each press, the currently programmed status will be shown in
the large four digit display. To adjust any displayed value, simply press the
WARMER

or COOLER

button.

3. Press SELECT

button to move down the menu from Start Time to

Duration, with each press, the currently programmed duration will be shown in
the large four-digit display. Press WARMER

or COOLER

button to

adjust the duration in increments of 15 minutes.

4. Press DISPLAY

button to save changes and recall the main water

temperature display. Note: If no button is pressed within 30 seconds, all
changes are recorded and the screen automatically returns to the standard
water temperature display.

*Note: Number will
vary according to which
filter cycle is being
programmed.

*Note: Number will
vary according to which
filter cycle is being
programmed.

This manual is related to the following products: