Jacuzzi J - 480 - Manual (Page 42)

Page 38
J-400 Series
11.5 Locking Filter Cycles
You may keep all filter cycle programs from being inadvertently altered by elec-
tronically “locking” them.
• To Lock All Filter Cycles: Press CYCLE
button, then within
30 seconds, press DISPLAY , MODE and WARMER
buttons within five seconds each. A padlock symbol will appear on
the screen. In this state, the status of the cycle program may be checked, but
may not be altered.
• To Unlock Filter Cycles: Press DISPLAY , MODE and
COOLER buttons within five seconds each.
11.6 Temperature Setting Lock
The spa’s temperature setting can be locked to prevent unauthorized
changes .
When locked, all other spa buttons and functions remain undisturbed.
• To Lock Temperature Setting: Press WARMER or COOLER
button to display temperature setting, then immediately press
the DISPLAY , MODE , and WARMER buttons
within five seconds each. A padlock symbol will appear on the screen.
• To Unlock Temperature Setting: Press WARMER or
COOLER button to display temperature setting, then imme-
diately press the DISPLAY , MODE , and COOLER
buttons within five seconds each.
11.7 Programming the Change Filter Reminder
Your new spa is equipped with a programmable “Change Filter” reminder icon
that flashes on the control panel display after a specified number of
days. It is designed to remind you to clean the skimmer filter cartridge
on a regular basis but does not affect spa operation in any way. The
“Change Filter” reminder must be reset at each filter cleaning interval.
It offers a selectable range from 10-120 days or can be disabled (turned off).
We recommend an initial setting of 60 days (2 months) to remind you to check
your filters after your first 2 months of operation. At this time, you can easily
determine whether you need to change this interval by visually inspecting the
filter cartridge an polishing bag. Note: This reminder must be reset at each filter
cleaning interval. Refer to section 12.1 for filter cleaning instructions.
Programming Instructions
1. Press the CYCLE
button 2 times. The main display reads “FIL” indi-
cating the “Change Filter” display program has been accessed.
2. Press SELECT button once to display the currently programmed dura-
tion or to view days elapsed since last filter cleaning interval.
LOCKED LOCKED
LOCKED LOCKED
LOCKED LOCKED
LOCKED LOCKED