J-400 series – Jacuzzi J - 480 User Manual
Page 52

Page 48
J-400 Series
POOR JET ACTION
(see page
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (page
).
WATER IS TOO HOT
1. Reduce thermostat setting (page
2. Switch hot tub to “Economy” mode to turn
heater on only during programmed filter
cycles (page
NO HEAT
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If “heater on” indicator is lit (page
temperature rise is experienced after a reason-
able period of time, contact your dealer or
authorized service center.
FILTER/CIRCULATION
PUMP OFF
1. Verify filter/circulation pump is programmed
).
2. Filter/circulation pump cycle canceled by
power interruption. Wait 24 hours for hot tub
to reset.
3. Hot tub water is warmer than 95°F (35°C)
and two degrees warmer than the set tempera-
ture. The “Summer Logic” safety feature has
activated. See note on page
Jacuzzi builds the best spas in the industry. Nonetheless, we are always striving
to improve the quality and features of our products. Your input as a Jacuzzi spa
owner is a cherished part of this process. If you have any comments or sugges-
tions, or if you wish to be informed on any new products for your spa, please
write to us.
CONGRATULATIONS on your good taste and welcome to the happiest and
most relaxed family in the world!