0 spa fill up procedure, Spa fill up procedure, J-400 series – Jacuzzi J - 480 User Manual
Page 16

Page 12
J-400 Series
Export J-460/J-465/J-470/J-480 Models (50Hz)
Voltage:
240VAC
240VAC
240VAC
Max. Current Draw:
16A
21A
29A
Frequency:
50Hz
50Hz
60Hz
Number of Wires:
3
3
3
Circuit Breaker (2-Pole):
20A*
30A**
40A***
* In 20A configuration, the heater will not operate while either jets pump
is running.
** In 30A configuration, the heater will not operate while both jets pumps
are running.
This is the factory setting.
*** In 40A configuration the heater will operate while both jets pumps are
running.
7.0 Spa Fill Up Procedure
FOR BEST RESULTS, READ EACH STEP IN ITS ENTIRETY BEFORE
PROCEEDING WITH
THIS PROCEDURE
.
1. Prepare The Spa For Filling
• Clear all debris from the spa. (Although the spa shell has been polished at
the factory, you may want to treat it with a specially formulated spa cleaner.
Consult your authorized Jacuzzi dealer for additional information prior to
filling spa.
• Remove both ProClear™
Plus skimmer
and polishing filter lids and filters as
illustrated in section 12.1 (page
).
2. Fill Spa
• Place the end of your garden hose into empty skimming filter bucket (filter
bucket on your left) as you stand next to the spa. Fill spa half way, then
place the garden hose into the opposite filter bucket (filter bucket on your
right) while adding the remaining fill water.
CAUTION: Never fill with water from a water softener. If your water
is extremely “hard”, it is preferable to fill half-way with hard water
and the rest of the way with softened water. Or, you may fill entirely
with hard water if you use a special water additive available from
your authorized Jacuzzi dealer.