English, Basic operations preparation for playing, Inserting/removing disc(s) – JVC XL-MV35TN User Manual

Page 11: Starting to play disc(s), Using number keys

Page 7

English

XL-MV35TN

LVT0023-001A

[ U, UF ]

BASIC OPERATIONS

Preparation for playing

Turn on the television set, amplifier or receiver to which the Player
is connected. Then select the proper channel and mode to
operate the Player, and set the sound volume to a reasonable
level.

Press the POWER button on the front panel or remote control.

The STANDBY indicator
goes out.

The display window shows the initial information as shown below.

POWER

STANDBY

ON/STANDBY

Easy start up

Without pressing the POWER button you can start up the Player by

pressing

SELECT button or disc buttons.

Inserting/removing disc(s)

Press the

(OPEN/CLOSE) button (1 through 3) to open the disc

tray. Then place the disc in the round recess of the tray with label
side up. To close the tray, press the

(OPEN/CLOSE) button

again.

If you press the

(OPEN/CLOSE) button of the disc which is playing,

the Player stops and then opens the tray.
If you press the

(OPEN/CLOSE) button of a disc that is not being

played, you can change discs without stopping play.

Note
•

When loading a disc in the disc tray, be sure to position the disc
inside the recess. Otherwise, the disc will be damaged when the
disc tray is closed, and the disc cannot be removed from the unit.

CORRECT

Tray

INCORRECT

Starting to play disc(s)

Press the

SELECT (PLAY) button. The Player starts to play from

the disc indicated in the display window.
Press one of the DISC 1 through 3 buttons and the Player plays the
disc you pressed, from the 1st track. For individual track selec-
tion, use the number keys or the

PREV/NEXT buttons.

SELECT

When you start play, the Display window shows the disc number and
the track number being played.
During play, the indicator on the DISC button blinks.
If the PBC function is activated, the display window shows “Pb” until
you play a track, and the television screen shows the initial menu, DISC
number, and “PBC”. See page 18, “Operation of Playback Control
function”.
When you press

SELECT button during play, the disc will restart

from the beginning of the track except when the PBC function is
activated.

Using number keys

Press the number keys to select numbers.

On the Player .................... 1 to 10 and +10 key
Example: For number 5, press 5. For number 15, press +10, then 5.
For number 20, press +10 button, then 10. For number 32, press +10
three times, then 2.

On the remote control ..... 1 to 10 and +10 key
Select numbers as described above.

+10

Note
•

When you press the number keys, the track will start playing without
pressing

SELECT button.