Installation/connection manual, Warnings, Parts list for installation and connection – JVC GET0570-001A User Manual

Page 155: English

KD-R406/KD-R405

Installation/Connection Manual

GET0571-010A

[UT]

J
Handles

F
Washer (ш5)

ш5

G
Lock nut (M5)

H
Mounting bolt (M4

× 5 mm; M5 × 12.5 mm)

M4 × 5 mm; M5 × 12.5 mm

A / B
Hard case/Control panel

C
Sleeve

D
Trim plate

E
Power cord

ENGLISH

This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does
not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.

Parts list for installation and connection

The following parts are provided for this unit. If any item is missing, consult your JVC car audio dealer
immediately.

K
Remote controller

L
Battery

0808DTSMDTJEIN

EN, CT

PRECAUTIONS on power supply and speaker connections:

• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit

will be seriously damaged.

• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in

your car.

Heat sink /

WARNINGS

To prevent short circuits, we recommend that you disconnect the battery’s negative terminal and make all
electrical connections before installing the unit.
• Be sure to ground this unit to the car’s chassis again after installation.

Notes:
• Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio

dealer.

• It is recommended to connect speakers with a maximum power of more than 50 W (both at the rear and

at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than 50 W, change “AMP
GAIN” setting to prevent the speakers from being damaged (see page 22 of the INSTRUCTIONS).

• To prevent short circuits, cover the terminals of the UNUSED leads with insulating tape.
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.

12 V

JVC

•

JVC

•

50 W

4 Ω

8 Ω

50 W

AMP GAIN

•

•
•

JVC

I
Rubber cushion

Install1_KD-R406[UT]_CT_1.indd 1

2008.9.3 2:39:38 PM