John Lewis JLDWW 905 - Manual (Page 21)

1. Check that the baskets have
been loaded correctly and that
the spray arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Press the On/Off button
The On/Off indicator light and all the programme
indicator lights illuminate.
5. Setting and starting the
programme
To select a programme, press the button of the
programme you wish to select, (see "Washing
programmes" chart), the indicator light of the selected
programme button remains illuminated while the other
programme indicator lights turn off. In the digital display
will appear, flashing, the running time of the programme
that has been set (in minutes).
The indicator lights of the phases foreseen for that
programme and the “Programme time” back light
will illuminate.
Select, if desired, within 3 seconds, the “Half load” option
(be sure that the option is available with the selected
washing programme).
After about 3 seconds from the last pressure of a button
the programme starts automatically.
In the digital display the running time of the programme is
no longer flashing, the Programme time back light
remains illuminated and the indicator lights of the phases
will turn off except for the phase underway.
Setting and starting the programme with
the delay start
The setting of the delay start occurs before selecting
the programme
Press the delay start button until the flashing number of
the hours for the delay start will appear in the digital
display (from 1h to 19h).
“Delay start” back light illuminates.
Select a washing programme (see “Washing programmes”
chart). In the digital display will appear, for a moment, the
running time of the programme and then again appears
the selected delay start time.
As soon as the number of hours is displayed without
flashing, the countdown for the delay start is active.The
countdown will decrease with steps of 1 hour.
The opening of the door during the countdown will not
modify the delay start.
Once the delay start has elapsed the programme will
start automatically.
Note: With the delay start function set, the
“Programme time” back light is off. Once the
countdown of the delay start has elapsed, the washing
programme will start automatically and the “Programme
time” back light will illuminate.
Note: it is possible to select a washing programme and
the delay start with the door open.
In this case the start of the programme or the count-
down will only commence after the closure of the door.
Until that moment it is possible to modify the settings
made.
6. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing
programme in progress ONLY if it’s
absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
Interrupt a washing programme in
progress
a) Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point at which it was interrupted.
b) Press the On/Off button, in this case all the indicator
lights turn off. Press the On/Off button again; the
programme will start from the point at which it was
interrupted.
Cancel a washing programme in progress
To cancel a washing programme you have to reset the
dishwasher; press simultaneously function buttons 1 and
2 for about 2 seconds.After about 2 seconds all the
programme indicator lights will illuminate indicating that
the running programme has been cancelled.
If a new washing programme is to be selected, check that
there is detergent in the detergent dispenser.
7. To cancel a delay start
To cancel a delay start in progress you have to reset the
dishwasher; follow the same instructions given in “Cancel
a washing programme in progress”. Cancelling a delay
start involves also the cancelling of the washing
programme set.
In this case you have to set the washing programme
again.
Starting a Washing Programme
21