John Lewis JLDWW 905 - Manual (Page 14)

Rinse aid
Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by
pressing the release
button (A).
2. Add the rinse aid until
the container is
completely full.
The maximum level for
filling is indicated by
"max".
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during
the next wash.
Only use branded rinse aid for dishwashers, available also
from your local John Lewis store.
Never fill the rinse aid dispenser with any other
substances (e.g. dishwasher cleaning agent, liquid
detergent).This would damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (position 1
minimum dosage, position 6 maximum dosage).
The dose is factory set in position 4.
Increase the dose if there
are drops of water or lime
spots on the dishes after
washing.
Reduce it if there are sticky
whitish streaks on the
dishes or a bluish film on
glassware or knife blades.
Top up the rinse aid when the indicator light on the
control panel illuminates.
14