John Lewis JLDWW 905 - Manual (Page 11)

10. Multi tab button
This appliance is equipped with the “Multi tab” function, that
allows the use of the combi detergent tablets with a combined
cleaning, rinsing and salt function (“3 in 1”,“4 in 1” etc...).
Before using the “Multi tab” function, check that
the water hardness level in your area complies
with the detergent manufacturers
recommendations.
This function can be selected with all washing programmes.
With the selection of this function the inflow of rinse aid and salt
from each respective supply container is automatically
deactivated and also the indicator lights for salt and rinse aid are
deactivated.
Select the “Multi tab” function before the set of a washing
programme.
Once selected this option ( Multi tab back light illuminated) it
will remain active also for the following washing programmes.
To deactivate the function, press the button (
Multi tab back
light off).
With the use of the “Multi tab” function, the cycle durations
may change. In this case, in the digital display, the indication of the
running time of the programme is automatically updated.
NOTE: Once the programme is running, the “Multi tab”
function can NO longer be changed. If you want to exclude the
“Multi tab” function you have to cancel the programme setting
(see chapter "Starting a washing programme" - "Cancel a washing
programme in progress") and then deactivate the “Multi tab”
function. In this case you have to set a washing programme (and
desired options) again.
NOTE: if the drying results are not satisfactory we suggest that
you activate the rinse aid dispenser.
The activation/deactivation of the rinse aid dispenser can only be
possible with the “Multi tab” function active.
Activation/deactivation of the rinse aid
dispenser
The dishwasher must be switched off
When the rinse aid dispenser has been activated, the
rinse aid indicator light on the control panel is
automatically activated.
1. Press the On/Off button.The On/Off indicator light and all
the programme indicator lights will illuminate (setting mode).
If only one programme button indicator light is on, this means that
a washing programme is set.The programme must be cancelled:
press simultaneously function buttons 1 and 2 for about 2
seconds.All programme indicator lights will illuminate indicating
that the set programme has been cancelled and the machine is
now in setting mode.
2. Press simultaneously function buttons 1 and 2, until the
indicator lights of function buttons 1, 2 and 3 start flashing.
3. Press function button 2, the indicator lights of function
buttons 1 and 3 turn off while the indicator light of function
button 2 goes on flashing, the digital display indicates the
current setting.
4. To change the setting, press function button 2 again, the
digital display indicates the new setting.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off button.
11. Half load button
This option is useful and economical when only a small load
needs washing reducing the consumption of water and energy.
This option must be linked to the selection of a washing
programme. (Programmes with this option are indicated in the
"Washing programmes" chart on page 20).
When selected, a back light will illuminate "Half load".
Load the dishes into both baskets (upper basket and lower
basket).
When using this option we recommend to reduce the dose of
detergent that is normally used for a complete load.
11
Rinse aid dispenser deactivated
Rinse aid dispenser activated