Jaguar X-Type JJM 21 02 20/15 - Manual (Page 73)

On the road 4-17
Changing the set speed
There are three ways to change the set
speed:
1. Accelerate or decelerate to the desired
speed then press the SET (+) button.
2. Increase or decrease the speed by
pressing and holding either SET (+)
or (–) until the desired speed is
obtained, then release the switch.
3. Increase or decrease the speed in steps
of 2 km/h by briefly pressing either the
SET (+) or (–) until the desired speed is
obtained.
Resuming the set speed
If the vehicle is accelerated above the set
speed, then the set speed will be resumed
when the accelerator pedal is released.
If CANCEL is pressed, or the brake or
clutch pedal is pressed, the cruise control
will disengage but the set speed memory
will be retained. Press RESUME and the
vehicle will return to the set speed.
Note: Cruise control will not resume at
speeds below 40 km/h.
RESUME will not operate if the ON/OFF
switch has been pressed to switch the
system off or if the ignition has been
turned off.
Caution:
1. RESUME should only be used if the
driver is aware of the set speed
and intends to return to it.
2. It is not recommended to resume
set speed when a low gear is
selected as excessive engine
speeds will occur.
Cruise control will switch off
and clear the memory when:
• The ON/OFF switch is set to OFF. The
warning light in the instrument cluster
will go out. A message CRUISE
CONTROL OFF will be shown in the
message centre.
• The ignition is switched to
position ‘0’.
• A fault occurs. The cruise control
system will switch OFF and cannot be
used until the fault is cleared.
Cruise control automatic
switch off
Cruise control will switch off but the set
speed will remain in the memory when:
• The CANCEL button is pressed.
• The brake pedal is pressed.
• The handbrake is applied.
• Speed falls below
40 km/h.
• Neutral, Park or Reverse gear
positions are selected.
• Traction control or DSC is operating.
• The difference between the actual and
set speed is too great.
• When the vehicle reaches a maximum
speed of:
Manual 200 km/h
Auto 192 km/h.
• The accelerator pedal is used to
accelerate beyond the set speed for
too long a period.
• If the vehicle has a manual gearbox,
pressing the clutch pedal will also
disengage the cruise control.