Jaguar X-Type JJM 21 02 20/15 - Manual (Page 110)

5-6 Climate control
Air recirculation
Press the button briefly to
select timed air recirculation.
To select latched air
recirculation, press and hold the button
until the LED flashes four times then
remains illuminated.
To deselect air recirculation and open the
fresh air intake, press the button again
(LED off).
Note that air recirculation cannot be
selected in position A (defrost) of the air
distribution control.
Select air recirculation to stop outside
odours from entering the vehicle or to
help cool the interior.
!
WARNING:
Prolonged operation with
recirculation selected in cold, damp
conditions could result in interior
condensation.
Air conditioning
The air conditioning only
operates with the fan switched
on and will switch off if fan
position 0 is selected.
If the air distribution control is set to any
of the screen defrost/demist positions (A,
B, C, G), the air conditioner switches on
automatically.
Air conditioning cannot be deselected in
defrost position A.
Heated front and rear screens
Pressing the push button selects
the front screen heater
(if fitted), provided the engine
is running.
The front heater switches off
automatically after 3 minutes or can be
switched off by pressing the button again.
Pressing the button selects the
rear screen heater and both
door mirror heaters, provided
the engine is running.
The rear screen and door mirror heaters
switch off automatically after 6 minutes
or can be switched off by pressing the
button again.
Windscreen defrost/demist
Frost and heavy misting
To remove frost or heavy misting from the
windscreen:
1. Start the engine.
3. Set the temperature control to
maximum to remove frost.
4. Select a fan speed, preferably
maximum (position 6). The air
conditioning will switch on
automatically.
5. If fitted, select the front windscreen
heater.
6. If required, select the rear screen
heater; this control also switches on
both door mirror heaters.
Light misting
To prevent or remove light
windscreen misting, select air
distribution position C.
2. Turn the air distribution mode
control to the defrost/demist
position (A).