beautypg.com

12 security and locks, Homelink, Universal transceiver – Jaguar X-Type JJM 21 02 20/15 User Manual

Page 30

background image

2-12 Security and locks

HomeLink

®

Universal

Transceiver

The HomeLink Universal Transceiver is

fitted in the roof console. HomeLink can

be programmed to transmit the radio

frequencies of up to three different

transmitters used to activate garage

doors, gates, home lighting, security

systems, or other radio frequency

operated devices.
If you would like additional information

on the HomeLink Universal Transceiver,

compatible products or to purchase other

accessories such as the HomeLink lighting

package, contact your Jaguar Dealer or

HomeLink at www.homelink.jci.com.

!

WARNING:

1. Do not use the HomeLink

Universal Transceiver with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
A garage door opener which
cannot detect an object, signalling
the door to stop and reverse, does
not meet current federal safety
standards. Using a garage door
opener without these features
increases risk of serious injury or
death.

2. When programming the

HomeLink Universal Transceiver
to a garage door opener or entry
gate, make sure that people, the
vehicle and objects are out of the
way to prevent potential harm or
damage as the gate or garage door
will activate during the
programme.

Programming
Note:
For best results, fit a new battery to

the hand-held transmitter before

programming. If your garage door opener

receiver (located in the garage) is

equipped with an antenna, ensure that the

antenna is hanging straight down.
1. Switch off the engine.
2. Press and hold the two outermost

buttons (1 and 3), releasing only when

the indicator light begins to flash after

20 seconds. Do not repeat this step

when programming the additional

buttons.

3. Hold the end of the hand-held

transmitter of the device you wish to

train approximately 25 to 75 mm

(1 to 3 inches) away from the

HomeLink surface, keeping the

indicator light in view.

4. Using both hands, simultaneously

push the hand-held transmitter button

and the chosen HomeLink button (1, 2

or 3). The HomeLink indicator light

will flash, first slowly and then rapidly.

When the indicator light flashes

rapidly, release both buttons. The

rapid flashing light indicates successful

programming of the frequency signal.

To programme the remaining buttons,

follow steps 3 and 4.