JVC GR-D370AH - Manual (Page 18)

GETTING STARTED 18
EN
MasterPage: Left
1
Adjust the velcro strip.
2
Pass your right hand
through the loop and
grasp the grip.
3
Adjust your thumb and
fingers through the grip to
easily operate the
Recording Start/Stop
Button, Power Switch and
Power Zoom Lever. Be
sure to fasten the velcro strip to your preference.
1
Set the Power Switch to “REC” while pressing
down the Lock Button located on the switch.
2
Make sure the LCD monitor is closed and
locked. Pull out the viewfinder fully and adjust it
manually for best viewability.
3
Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
CAUTION:
When retracting the viewfinder, take care not to
pinch your fingers.
1
Set the Power Switch
to “REC” or “PLAY” while
pressing down the Lock
Button located on the
switch.
2
Open the LCD monitor
fully. ( ੬ pg. 20)
● To adjust the brightness of
the viewfinder, pull out the
viewfinder fully and set
“PRIORITY” to “FINDER”
(
੬ pg. 32, 34).
3
Press MENU . The
Menu Screen appears. If
you are in Playback mode,
please proceed to step
5 .
4
Press 4 , 3 , 1 or 2 to select “DISPLAY”, and
press SET. The DISPLAY Menu appears.
5
Press 4, 3, 1 or 2 to select “BRIGHT”, and
press SET. The Menu Screen closes and the
brightness control MENU appears.
6
Press 4 or 3 until the appropriate brightness
is reached and press SET or 2.
7
Press MENU. The menu screen closes.
To attach the camcorder
to a tripod, align the
direction stud and screw
to the mounting socket
and stud hole on the
camcorder. Then tighten
the screw clockwise.
● Some tripods are not
equipped with studs.
Grip Adjustment
Viewfinder Adjustment
Dioptre Adjustment Control
Example:
Brightness Adjustment Of The
Display
Tripod Mounting
BRIGHT
– 5
1 1 1 1
2 2 2 2
MENU
4 4 4 4
3 3 3 3
GR-D370AH_EN.book Page 18 Monday, April 17, 2006 2:24 PM