JVC ShowView LPT1100-001A - Manual (Page 40)

Filename [DX5SEU_08DV Operation.fm]
Masterpage:Left+
40
EN
BASIC OPERATIONS ON DV DECK
Page 40Thursday, 1 September 2005 13:26
Variable Speed Search
During playback, press N for forward variable speed search, or
O for reverse variable speed search.
● Each press of the button increases the search speed for each
direction.
● To resume normal playback, press I.
Still Picture/Frame-By-Frame Playback
1
Press W to pause during playback.
2
Press W to activate frame-by-frame playback.
● To resume normal playback, press I.
Slow Motion
1
Press W to pause during playback.
2
Press and hold W for 2 seconds, then release. Press W and
release again to return to still picture.
● Press N for forward slow motion or O for reverse slow
motion.
● To resume normal playback, press I.
Skip Search
During playback, press v.
● Each press initiates an approximately 30-second period of fast-
motion playback. Normal playback resumes automatically.
One Touch Replay
During playback, press w. The unit rewinds the picture a little (about
7 seconds) and resumes playback.
Next Function Memory
The Next Function Memory AtellsB the unit what to do after rewinding.
Before continuing, make sure the unit is in the Stop mode.
For Automatic Start Of Playback
Press
O, then press I within 2 seconds.
Soundtrack Selection
Your unit is capable of recording two soundtracks (L and R) and will
play back the one you select.
During Playback
Pressing AUDIO changes the soundtrack as follows:
To select the audio mode (SOUND1/SOUND2/MIX), refer to
AAUDIO MODEB under ADV SET UPB (A pg. 72).
NOTE:
For instructions on recording stereo and bilingual programmes,
refer to page 34.
Time Code
During recording, a time code is recorded on the tape. This time
code is used to confirm the position on the tape when playing back
or editing a tape.
1
Press DISPLAY until the time code on the tape appears on the
front display panel and the TV screen.
● Each time you press DISPLAY, the indication changes as
follows:
Tape remaining time N Time code N Clock time N (Back to the
beginning)
Playback Features
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
● Press DV/HDD/DVD SELECT on the unit repeatedly or DV on
the remote so that the DV lamp lights up on the unit.
ATTENTION:
In the search, still, slow-motion or frame-by-frame playback
mode, a slight mosaic effect appears on screen.
W
DV
AUDIO
DISPLAY
I
N O
1
CABLE/SAT
DVD TV
1 2 4 12 - 1 5 1 5 - 2 - 4 -12
Reverse O
Reverse Search
3 steps
Reverse
Slow Motion
1 step
Normal Play
Slow Motion
1 step
N Forward
Forward Search
3 steps
TRACK
USE
On-Screen Display
L W X R For stereo or Bilingual tapes
L W For main audio of Bilingual tapes
X R For sub audio of Bilingual tapes
DX5SEU_00.book Page 40 Thursday, September 1, 2005 1:26 PM