JVC 0803AIMMDWJEM - Manual (Page 16)

13
English
Setting the AM Tuner Interval Spacing
Some countries AM channel intervals are set to 9 kHz apart,
and some countries use 10 kHz apart.
When shipped, the built-in AM tuner is set to 9 kHz spacing.
You can change the channel interval to 9 kHz or 10 kHz
spacing.
On the unit ONLY:
To set the AM tuner to the 10 kHz spacing, be sure that the
unit is turned off (on standby), but is plugged into a wall outlet.
Press
(standby/on) while holding
¢. The unit turns on
and tunes in to 530 kHz.
To set it back to the 9 kHz spacing, be sure that the unit is
turned off (on standby), but is plugged into a wall outlet.
Press
(standby/on) while holding 4. The unit turns on
and tunes in to 531 kHz.
When you change the AM channel interval spacing
The preset stations you have set (both FM and AM) will be erased. In this
case, preset stations again. See “Presetting Stations” on page 14.
Tuning in to a Station
1
Press FM/AM/AUX (or FM/AM on the unit)
to select either “FM” or “AM.”
The unit automatically turns on and tunes in to the
previously received station—either FM or AM.
• Each time you press the button, the band changes as
follows:
On the remote control:
* For operating the external equipment, see page 27 and the manuals
supplied with it.
On the unit:
2
Press and hold
¢ or 4 for more than 1
second.
• ¢: Increases the frequencies.
• 4: Decreases the frequencies.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
• If an FM program is broadcast in stereo, the STEREO
indicator lights up on the display (only when the
reception is good).
To stop during searching, press ¢ or 4.
When you press ¢ or 4 repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is noisy or hard to receive, you
can change the FM reception mode to improve the reception.
On the remote control ONLY:
Press FM MODE so that the MONO indicator
lights up on the display.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off. In stereo mode, you can hear
stereo sound when a stereo program is broadcast.
• The STEREO indicator lights up only when the reception is
sufficient.
Listening to FM and AM Broadcasts
¢ UP
4 DOWN
FM/AM
/AUX AUX/DVD
FM/AM
(On the remote control) (On the unit)
GROUP SKIP GROUP SKIP
¢ 4 UP DOWN
(On the remote control) (On the unit)
FM
MODE
FM AM
FM AM AUX*
EN13-14_UX-J55MD[UB]f.p65 7/1/03, 5:33 PM 13