IBM CP-X445 - Manual (Page 31)

31
Multifunctional settings
VIDEO Qlty. Menu
With the VIDEO Qlty. menu, items shown in the table below
can be performed.
Select an item using the cursor buttons ▲/▼ on the
projector or remote control, and press the cursor button ►
on the projector or remote control, or the ENTER button on
the remote control to progress. Then perform it referring to
the following table.
Item Description
PROGRESSIVE
Using the buttons ▲/▼ switches the progressive mode.
TV  FILM  TURN OFF
• This function performs only at an interlaced signal of a VIDEO
input, a S-VIDEO input or a COMPONENT VIDEO input of 525i
(480i) or 625i (576i) signal.
• When the TV or FILM is selected, the screen image will be crisper.
The FILM mode is adaptable to the 2-3 Pull-Down system to the
conversion. But these may cause a certain defect (for example,
jagged line) of the picture at a quick moving object. In such a case,
please select the TURN OFF, even though the screen image may
lose the crisp.
3D-YCS
Using the buttons ▲/▼ switches the 3D-YCS mode.
STILL IMAGE  NORMAL  TURN OFF
• This function performs only at a VIDEO input of NTSC 3.58.
• NORMAL is the mode for images with a lot of motions like movies,
and STILL IMAGE is the mode for images with few motions or
completely still ones like slides.
• When this function performs, the VIDEO NR function is ineffective.
VIDEO NR
Using the buttons ▲/▼ switches the noise reduction mode.
HIGH  MIDDLE  LOW
• This function performs only at a VIDEO input or a S-VIDEO input.
At a VIDEO input of NTSC 3.58, this function performs only when
the TURN OFF is selected under the 3D-YCS.
• When the HIGH, the MIDDLE or the LOW is selected, the noise
on screen is reduced according to each mode.
• When this function is excessive, it may cause a certain
degradation of the picture.
MENU [RGB]
IMAGE
PICTURE
:SELECT
SETUP
INPUT
OPTION
EASY MENU
SCREEN
VIDEO Qlty.
NETWORK
PROGRESSIVE TURN OFF
3D‑YCS TURN OFF
VIDEO NR LOW