IBM CP-X445 - Manual (Page 14)

14
Putting batteries
WARNING ►Always handle the batteries with care and use them only as
directed. Improper use may result in battery explosion, cracking or leakage,
which could result in fire, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specified. Do not use batteries of different
types at the same time. Do not mix a new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
• Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry place.
• If you observe a leakage of a battery, wipe out the flower and then replace a battery.
If the flower adheres your body or clothes, rinse well with water immediately.
1.
Remove the battery cover.
Slide back and remove the battery cover in the direction of the arrow.
2.
I nsert the batteries.
Align and insert the two AA batteries according to their plus and minus
terminals as indicated in the remote control.
3.
Close the battery cover.
Replace the battery cover in the direction of the arrow and snap it back into place.
Remote control
Laser pointer
This remote control has a laser pointer in place of a finger or rod. The laser beam works
and theLASER INDICATOR lights while the LASER button is pressed.
WARNING ►The laser pointer of the remote control is used in place of a
finger or rod. Never look directly into the laser beam outlet or point the laser
beam at other people. The laser beam can cause vision problems.
CAUTION ►Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation exposure.
Remote control
STANDBY/ON
VID EO
UP
DOW N
BLA NK
ASPEC T
PU SH
LAS ER
IND ICA TOR
LAS ER
RG B
EN TER
ON
OF F
ESC
POSITION
MAG NIFY MU TE
KEYST ONE
FREEZ
E
ONE TOUCH
AUT O
PAG E
ME NU
RE SET
VOL UME