Chapter 2. setting up the projector, Starting and shutting down the projector, Chapter – IBM Partner Pavilion PROJECTOR M400 User Manual
Page 21: Setting, Projector, Starting, Shutting, Down
Chapter
2.
Setting
up
the
projector
This
chapter
provides
information
on
positioning
the
projector,
connecting
a
computer
source,
using
the
projector
with
Microsoft
Windows,
and
displaying
and
adjusting
a
computer
source
image.
Starting
and
shutting
down
the
projector
Please
follow
the
steps
below
to
start
your
projector,
and
to
shut
off
the
projector.
Attention:
Before
moving
the
projector,
be
sure
to
power
down
the
projector
normally
and
disconnect
the
projector
from
the
main
power
source.
1.
Connect
the
power
cord
to
the
projector
as
shown
in
Figure
2-1.
Connect
the
other
end
to
a
wall
outlet.
The
Power
LED
turns
on.
2.
Remove
the
lens
cover.
3.
Attach
input
devices.
4.
Turn
on
the
connected
devices.
5.
Ensure
the
Power
LED
is
on
a
steady
(not
flashing)
amber
and
then
press
the
Power
button
to
turn
on
the
projector.
The
projector
splash
screen
displays
and
connected
devices
are
detected.
Attention:
Do
not
look
directly
into
the
projection
lens
when
the
lamp
is
turned
on.
The
bright
light
might
harm
your
eyes.
6.
Use
the
appropriate
appliance
cable
to
connect
to
a
video
device.
7.
To
turn
off
the
projector,
press
the
Power
button.
The
projector
prepares
for
shut-down
and
a
″Power
off
″
message
appears,
as
shown
below.
The
projector
turns
off
automatically
within
5
seconds.
Note:
This
operation
can
be
cancelled
by
pressing
a
button
other
than
the
Power
button.
Pressing
the
Power
button
again
will
switch
off
power.
Figure
2-1.
Connecting
the
power
cable
©
Copyright
IBM
Corp.
2004
2-1