Interquartz IQ750 - Manual (Page 35)

35
PAUSE FUNCTION WHEN DIALING OUT
Sometimes a pause is necessary either when dialling ordirnary outgoing calls,
accessing specialised network features or perhaps when storing certain numbers in
the memory. If you have determined that a pause is required by your host system,
please refer to the information below. If you have already experienced dialling difficulties,
try the suggestions below.
AUTOMATIC TRUNK ACCESS DIGIT INSERTION
When the telephone is used wherever a dialing prefix is required to make an external call
(eg. normally 0 is needed for an outside line), this prefix can be stored to ensure that it is
automatically dialled whenever an external number is dialled from the Caller List. This
resolves a problem found in Caller ID capable network environments where the caller ID
information delivered to the receiving telephone does not contain the outside line prefix
necessary to complete a call-back to that caller.
To setup, model IQ750 accepts a one or two digit Trunk Access Code as follows:
1. Press STORE
2. Enter the TRUNK ACCESS DIGIT (example, 0 for Customnet)
3. Press STORE
4. Press “ ” (STAR)
After programming digit 0 in the above example the unit will insert a 0 in front of any
outgoing number that is dialled from the Caller List (the list of incoming calls).
This setting remains set until the user changes it - removal of power sources or line
connection will not change the setting.
AUTOMATIC PAUSE INSERTION
The above procedure will also insert a pause after the access code before dialling the
actual number that has been selected for call-back from the Caller List. The pause time
can be pre-set (see below).