Interquartz IQ750 User Manual

Page 23

Direct Access Memory Capacity

Each memory can store up to 32 digits plus Pause,

Recall (Flash) and a Handsfree

code.

Speed-Dialling (Storable Handsfree code)

When storing a number, you can add a “Handsfree” command to the start of the number.

It appears as an “H” on-screen. This programming technique makes dialling faster and

easier – to commence dialling of any Direct Access memory programmed with a “Handsfree”

code the memory key can be pressed without the need to lift the handset or press the

Handsfree/Headset key.

Speed-Dialling and Automatic Hang-up

The Handsfree code may also be stored in a Direct Access memory key at the trailing

end of a stored number to make the telephone hang up immediately after dialling the

number.

Example (where “H” represents the Handsfree code and “nnnnn” represents any subsequent

digits to be dialled)

If H is entered as a prefix code:

Stored string: H nnnn

Result: The phone will go on-line in Handsfree mode and dial out the subsequent

number. Phone will remain on-line in handsfree mode until the user manually

hangs up.

If H is entered at both ends of the digits to be dialled

Stored string: H nnnnn H

Result: The phone will go on-line in Handsfree, dial out the number and go off line

again.

To store a Number and Name in a Direct Access memory

Press STORE; the display will show “STORE”

Press the Memory Key either once to store in a One-Touch memory or twice for a

Two-Touch memory; the display will show “ENTER NUMBER”

If you wish to setup the chosen memory key as a speed-dial key, go to step 4.

Otherwise go to step 5