Interquartz IQ750 - Manual (Page 14)

14
REDIAL KEY
Press to redial the last number last dialed, which may be up to 32 digits long. When
pressed while still on-line, the telephone will clear the call and retry the number. It can be
used in Handset, Handsfree, and Headset modes. Dialing more than 32 digits during one
call will cause erasure of the entire number from the Redial Memory.
See further details of the 5-stack Last Number Redial Memory in section 6 “Memory
Operation”.
To redial last number
1. Lift Handset, or press HANDSFREE/HEADSET
2. Press REDIAL (telephone redials last number).
To direct redial the last number
1. Lift Handset, or press HANDSFREE/HEADSET
2. Dial a number, [unsuccessful]
3. Press REDIAL; the telephone will automatically clear and re-connect the line; the
number will be re-dialed.
PAUSE FUNCTION
The Pause command may be needed if your phone is connected to certain types of
PABX or to any network where a momentary pause is required (e.g. between internal and
external dial tones).
For manual dialing:
1. Lift Handset
2. Dial any digits required before the pause
3. Press PAUSE; the telephone will complete the dialing process once the Pause
time has elapsed
4. Dial the remaining digits.
The Pause function can be stored in any Direct Access or Direct Memories. See section
8 for further details.
MUTE KEY AND INDICATOR
When pressed, it cuts off transmission from the Handset, Headset and Handsfree
microphones to allow user privacy. The red light indicates when the mute condition is
active. Press MUTE again to release the mute condition.