beautypg.com

Intel ATC6430M User Manual

Page 34

background image

ATC6430M Mainboard Chapter 3 Award BIOS Setup

31

Video Off Method This determines the manner in which the monitor is blanked.

V/H SYNC
+ Blank

This selection will cause the system to turn off the vertical and
horizontal sync. ports and write blanks to the video buffer.

Blank Screen

This option only writes blanks to the video buffer.

DPMS

Initial of “Display Power Management Signaling”.


Video off In Suspend This determines the manner in which the monitor is blanked.


Suspend Type
Select the suspend type.

Stop Grant

Only CPU enters sleeping mode

Full on Suspend Both CPU and chipset enter sleeping mode


MODEM Use IRQ
This item determines the IRQ in which the MODEM can be used.
The choice : 3,4,5,7,9,10,11,NA.

Suspend Mode
When enabled and after the set time of system inactivity, all devices
except the CPU will be shut off.

HDD Power Down When enabled and after the set time of system inactivity, the hard
disk drive will be powered down while all other devices remain active.

Soft-Off by PWR-BTTN Instant-off : When push the power button, the system
power will be off immediately. Delay 4 sec : when push the power button, it will enter
suspend mode. We need to push the power button and hold it for 4 seconds to turn
off the power.

PCI PME# Function With PCI card supporting PCI Power Management capability
and this item setting to Enabled, the system can be waked up by PCI card.

PowerOn by Ring
Enabled: when system is in suspend mode, it can be waked up by
modem. Disabled: it cannot be waked up by modem.

Resume by Alarm When Enabled, two additional lines will be added to the
screen :Date (of Month) Alarm; Time (hh:mm:ss) Alarm to let user set the desired date
and time. After power off, the system will automatically power on at the specified date
and time.

Reload Global Timer Events
When enabled, an event occurring on each device
listed below restarts the global time for Standby mode. IRQ [3-7, 9-15], NMI; Primary
IDE 0; Primary IDE 1; Secondary IDE0; Secondary IDE1; Floppy Disk; Serial Port;
Parallel Port.