Intel 3U Compact PCI - Manual (Page 27)

21 Chapter 4
Hard Disk Boot Priority
Set hard disk boot device priority.
CPU Thermal Monitor
The Intel Thermal MonitorAutomatic Mode. There are two Automatic
modes called Intel Thermal Monitor 1 (TM1) and Intel Thermal Monitor
2 (TM2). And MIC-3321 Auto dete C-M or P-M.When CPU was C-M
BIOS running in TM1,another running TM2.
TM1: When Intel Thermal Monitor 1 is enabled, and a high temperature
situation exists, the clock will be modulated by alternately turning the
clock off and on at a 50% duty cycle. Cycle times are processor speed
dependent, and will decrease linearly as processor core frequencies
increase. After the temperature has returned to a non-critical level, modu-
lation ceases and the TCC goes inactive.
TM2: When Intel Thermal Monitor 2 is enabled, and a high temperature
situation exists, the processor will perform an Enhanced Intel SpeedStep
technology transition to a lower operating point. When the processor tem-
perature drops below the critical level, the processor will make an
Enhanced Intel SpeedStep technology transition to the last requested
operating point. Intel Thermal Monitor 2 is the recommended mode on
the Intel Pentium M processor
Enabled (default) Enable Thermal Monitor
Disabled
Disable Thermal Monitor
Virus Warning
This will occur during and after the system boot up, or during any attempt
to sector or partition the hdd. While the message displays, an anti-virus
program will attempt to locate the problem. If the Virus Warning is dis-
abled, no warning message will ever appear.