Invacare PRONTO R2-250 User Manual

Page 20

G
G

FRONT RIGGINGS

PROCEDURE 3

FIGURE 12 - INSTALLING/REMOVING THE ONE

PIECE FOOTBOARD

Legrest

Tube

Support

Assembly

Adjustment

Lever

Seat

Frame

Pull

Ring

Detent Pin

Assembly

DETAIL “A”

Hex Head

portion of

Pull Ring

ADJUSTING THE ONE PIECE
FOOTBOARD - HEIGHT, ANGLE,
AND DEPTH

Height (FIGURE 13)

1. Remove the two (2) hub caps that cover the mount-

ing bolt of the footboard assembly.

2. Remove the mounting bolt, locknut, two (2) caplug

washers, two (2) large washers, and two (2) spac-
ers that secure the footboard assembly to the
legrest tube.

3. Raise or lower the footboard assembly to the de-

sired mounting position on the legrest tube.

NOTE: Do NOT cover the warning label on the legrest
tube shown in FIGURE 13.

4. Secure the footboard assembly to the legrest tube

in the position determined in STEP 3 with the
mounting bolt, two (2) cap caplug washers, two
(2) large washers, two (2) spacers and locknut.
Securely tighten.

5. Replace the two (2) hub caps.

FIGURE 13 - ADJUSTING THE FOOTBOARD HEIGHT

Caplug Washer

Locknut

Large

Washer

Caplug

Washer

Mounting

Bolt

Large

Washer

Hub Cap

Footboard

Spacers (Not Shown are positioned

between the legrest tube and the

footboard assembly.)

Warning Label

Angle (FIGURES 14 AND 15)

1. Loosen, DO NOT remove, the four (4) flat head

screws and barrel nuts that secure the footboard
to the two (2) half clamps.

2. Rotate the two (2) half clamps on the pivot hinge

until the desired angle is achieved.

3. Securely tighten the four (4) flat head screws to

the footboard and half clamps.

INSTALLING/REMOVING THE ONE
PIECE FOOTBOARD (FIGURE 12)

Installing the One Piece Footboard

1. Pull the detent pin out from the support assembly.

2. While pulling detent pin, insert the legrest tube of the one

piece footboard assembly into the support assembly.

WARNING

Before operating the wheelchair, ensure de-
tent pin is engaged, and adjustment lever is
securely tightened, otherwise, injury and/or
damage may result.

3. Visually inspect and ensure that the detent pin is

engaged.

4. Ensure pull ring is resting on the hex head portion of

the detent pin assembly. Refer to DETAIL “A”.

5. Securely tighten the adjustment lever.

Removing the One Piece Footboard

1. Loosen, but DO NOT remove, the adjustment le-

ver from the support assembly.

2. Pull the detent pin from the support assembly.

3. While pulling the detent pin, remove the one piece

footboard assembly from the support assembly.