Invacare PRONTO R2-250 - Manual (Page 18)

18
ADJUSTING REMOVABLE
FOOTBOARD
Depth (FIGURE 8)
1. Remove the four (4) flat head screws and barrel nuts
that secure the removable footboard to the two (2)
footplate clamps.
2. Move the removable footboard to one (1) of the four
(4) positions.
3. Reinstall the four (4) flat head screws and barrel nuts
that secure the removable footboard to the two (2)
footplate clamps. Tighten securely.
F
R
O
N
T
R
I
G
G
I
N
G
S
FRONT RIGGINGS PROCEDURE 3
Footplate
Clamp
Removable
Footboard
FIGURE 8 - ADJUSTING FLIP-UP
REMOVABLE FOOTBOARD - DEPTH
Mounting
Positions
Flat Head Screws
Barrel Nut
Barrel Nut
Angle (FIGURE 9)
1. Loosen, but do not remove, the four (4) flat head
screws and barrel nuts that secure the removable
footboard to the two (2) footplate clamps.
NOTE: Because of the two (2) support tubes, the
angle of the removable footboard can be adjusted
downward ONLY.
2. Grasp the front of the removable footboard and ro-
tate it DOWNWARD until the desired angle is
reached.
3. While holding the removable footboard in place,
tighten the four (4) flat head screws and barrel nuts
securely.
FIGURE 9 - ADJUSTING FLIP-UP REMOVABLE
FOOTBOARD - ADJUSTING FOOTBOARD ANGLE
Removable
Footboard
Barrel Nut
Flat
Head
Screw
Angle Can Be Adjusted
Downward ONLY
FRONT
Footplate
Clamp
Height (FIGURE 10)
1. Remove the removable footboard plate. Refer to
REMOVING THE REMOVEABLE FOOTBOARD
ASSEMBLY FROM THE WHEELCHAIR in this pro-
cedure of the manual.
2. Remove the caplug cap.
3. Remove the mounting screw, caplug washer, flat
washer and nut that secures the two (2) large wash-
ers and support tube to the height adjustment
bracket and footboard bracket. Refer to DETAIL
“A”.
4. Remove the nut, flat washer and that secure the
threaded arm on the height adjustment bracket to
the footboard bracket. Refer to DETAIL “B”.
5. Move the height adjustment bracket to one (1) of
seven (7) height positions.
6. Reinstall the flat washer and nut that secures the
threaded arm on the height adjustment bracket to
the footboard bracket. Refer to DETAIL “B”.
7. Reinstall the mounting screw, caplug washer, flat
washer and nut that secures the two (2) large
washers and support tube to the height adjust-
ment bracket and footboard bracket. Refer to
DETAIL “A”.
8. Reinstall the caplug caps.
9. Repeat STEPS 2-8 for the opposite footboard
bracket.
10. Reinstall the removable footboard plate. Refer to
REMOVING THE REMOVEABLE FOOTBOARD
ASSEMBLY FROM THE WHEELCHAIR in this pro-
cedure of the manual.