IOGear GWU513 - Manual (Page 29)

Note: The texts before “Wireless Settings” in the caption bar
of the dialog box are the profile name of the current
connection. Thus, the caption contexts vary according to the
connectivity at the given time. From the left picture, the
associated profile is named
“Default”. For more information
about profiles, please refer to the “The Configuration Tab”
section in the manual.
From the window, the general information on
the status of currently connected entry is
presented. You may want to click the
Rescan button to reinitiate the scanning
process and update the status. Later the
result of scanning will be renewed and
displayed in the window. If you wish to stop
the networking connection, click the Disable
Radio button to stop scanning. Meanwhile,
the State tab will indicate that the radio has
been stopped and the remaining areas
under this tab display either a zero or Not
27
Applicable. However, if you are already in the
disabled radio mode, you will find the Enable
Radio button here instead. Click Enable
Radio to regain the link then.
State:
Here displays the MAC Address of the current
associated entry, which could be a connected
access point in the Infrastructure mode or
computers joining in the Peer-to-Peer network.
Configuration Program Controls