User-programmable feature buttons – Inter-Tel Axxess User Manual
Page 183
Page 167
System Features
AXXESS
®
ADMINISTRATOR’S GUIDE – January 2004
User-Programmable Feature Buttons
USER-PROGRAMMABLE FEATURE BUTTONS
NOTE:
This feature does not apply to single-line sets.
Individual Inter-Tel phone buttons can be designated as “user-programmable” in the keymaps
during database programming. The installer can program the default feature codes, and the sta-
tion user can reprogram the feature codes as desired. Default phone feature codes are shown on
. Up to 35 user-programmable phone buttons can be programmed to enter any of the
general feature codes.
Inter-Tel display phones have a special
key when the buttons are in the default state.
(However, it can be reprogrammed to use any of the Forward feature codes.) When the
button is pressed, the display shows a menu of call forwarding options. The user must then
select the desired option by pressing the corresponding button next to the display. If the
button is programmed to use any other Forward feature code (355-358), the forwarding
options will not be displayed when the
button is pressed. Any Inter-Tel phone user can
make any user-programmable button a
button that uses any one of the forwarding fea-
ture codes (355-358).
Secondary extension buttons (described on
) can be assigned to user-programmable
buttons during keymap programming. If so, the phone user can determine the primary station
that is associated with the secondary extension button by using the feature button programming
procedures given below.
T
O
DISPLAY
THE
CURRENT
BUTTON
ENTRIES
:
1.
While on hook, enter the Review Keys code (396). The display shows PRESS THE
KEY TO REVIEW.
2.
Press the feature or speed-dial button(s) to be displayed. The display shows the feature,
username, or speed dial location name and KEY VALUE: (feature code, extension num-
ber, or location code). For a secondary extension button, the display shows SECOND-
ARY: (station).
T
O
RETURN
THE
BUTTONS
TO
DEFAULT
VALUES
:
While on or off hook, enter the Feature Key Default feature code (395). If off hook,
hang up. The display shows FEATURE KEYS DEFAULTED.
T
O
PROGRAM
A
FEATURE
CODE
IN
A
USER
-
PROGRAMMABLE
BUTTON
OR
ASSIGN
A
PRIMARY
STATION
TO
A
SECONDARY
EXTENSION
BUTTON
:
1.
While on hook, enter the Program Keys feature code (397). Display phones show
PRESS THE KEY TO PROGRAM.
2.
Press the desired feature or secondary extension button. The display shows the current
feature, station, or speed dial location name and KEY VALUE: (feature, extension, or
location code).
FWD
FWD
FWD
FWD
FWD