Impex WM 1407 - Manual (Page 6)

STEP 2 (See Diagram 2)
A.) Attach the Rear Support Frame (#4) onto the Base Frame (#5). Secure them with four M10 x
5/8” Allen Bolts (#40) and
∅
¾” Washers (#53).
B.) Attach the lower end of Diagonal Support Frame (#11) and the Vertical Lock Bracket (#14) to
the Rear Support Frame (#4). Align the holes then secure them together with two M10 x 2
3/8” Carriage Bolts (#39),
∅
¾” Washers (#53), and M10 Aircraft Nuts (#50). Do not tighten
the nuts and bolts yet.
C.) Attach the upper end of Diagonal Support (#11) to the Rear Vertical Frame (#9). Secure it
with one 2 3/8” x 3 ½” Bracket (#18), M10 x 2 3/8” Carriage Bolt (#39),
∅
¾” Washer (#53),
and M10 Aircraft Nut (#50) on the upper hole. Secure the lower hole with M10 x 2 3/8” Allen
Bolt (#43) and
∅
¾” Washer (#53). Tighten all nuts and bolts previously installed.
DIAGRAM 2
5