Intel ICH10R - Manual (Page 41)

36
3-11 Power User Overclock Setting
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Power User Overclock Setting
Help Item
Overclocking Configuration
CPU Bridge Configuration Press Enter
CPU Overclock 133
CPU Voltage at next boot Default
VDIMM Select Default
NB1.1 V Setting Default
Configure CPU Bridge Feature
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Discard Changes F6:Fail-Safe Defaults F7:Optimized Defaults
CPU Voltage at next Boot
Use this item to select CPU voltage at next boot. The optional settings are: Default; 1.2000
V~1.550V.
VDIMM Select
Use this item to select voltage for memory modules. The optional settings areL: Default;
1.525 V ~1.650V.
NB 1.1 V
The optional setting values are: Default; 1.150v; 1.200v and 1.250V.
CPU Bridge Configuration
Users can Press Enter to have a brief view of the CPU information and select relative values
for the following sub-items, which includes: QPI Link Speed; QPI Frequency; Memory
Frequency; memory Mode; Demand Scrubbing; Patrol Scrubbing and Throttling-closed loop;
Throttling-open loop.
QPI Frequency
The optional settings are: Auto; 4.800GT and 6.400 GT.
Memory Frequency
This item is used to force a DDR3 frequency slower than the common tCK detected via SPD.
3-12 BIOS Security Features
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
BIOS Security Features
Security Settings Help Item
Supervisor Password: Not Installed
User Password: Not Installed
Change Supervisor Password Press Enter
Change User Password Press Enter
Boot Sector Virus Protection Disabled
Install or change the
password
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Discard Changes F6:Fail-Safe Defaults F7:Optimized Defaults
You can set either supervisor or user password, or both of them. The differences are:
Supervisor password: Can enter and change the options of the setup menus.
User password: Can only enter but do not have the right to change the options of the setup
menus. When you select this function, the following message will appear at the center of
the screen to assist you in creating a password.
ENTER PASSWORD: