7-2 onboard device control, 7-3 super io configuration – Intel ICH10R User Manual

Page 36

Hard Disk Write Protection

Use this item to enable or disable hard disk write protection. This will be effective ony if the
device is accessed through BIOS.

IDE Detect Time Out(Sec)

Select the time out value for detecting ATA/ATA(PI) devices.

ATA(PI) 80 Pin Cable Detect( Host & Device; Host; Device)

Select the mechanism for detecting 80 pin ATA(PI) cable

3-7-2

Onboard Device Control

Help Item

Onboard PCIE LAN 1 Auto

Onboard PCIE LAN 2 Auto

Onboard PCIE Lan BootRom Disabled

JMicron 36x ATA Controller IDE Mode

HD Audio Controller Enabled

Options

Auto

Enabled

Disabled

↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help

F5:Discard Changes F6:Fail-Safe Defaults F7:Optimized Defaults

Onboard PCI E Lan 1/2
Use this item to enable or disable Onboard PCI E Lan.
JMicron 36x ATA Controller
Users can enable or disable ESATA and IDE interface though this item.
HD Audio Controller
This item allows you to decide to enable/disable the chipset family to support HD Audio. The
optional settings are: Auto; Enabled and Disabled.

3-7-3

Super IO Configuration

Configure F71887F Super IO Chipset

Help Item

Power On by keyboard Disabled

Power On by Mouse Disabled

Onboard Floppy Controller Enabled

Serial Port 1 Address 3F8/IRQ4

Serial Port 2 Address 2F8/IRQ3

Serial Port Mode IrDA

PWRON After PWR Fail Always Off

Options

Disabled
Enabled

↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help

F5:Discard Changes F6:Fail-Safe Defaults F7:Optimized Defaults

Onboard Floppy Controller
This item allows BIOS to enable or disable floppy controller.
Select Enabled if your system has a floppy disk controller (FDD) installed on the system
board and you wish to use it. If you install add-on FDC or the system has no floppy drive,
select Disabled in this field. The settings are: Enabled and Disabled.
Power On by keyboard

This manual is related to the following products: