Intel D845WN - Manual (Page 66)

Intel Desktop Boards D845HV and D845WN Product Guide
66
ATAPI CD-ROM Drives
Maintenance Main Advanced Security Power Boot Exit
Boot Device Priority
Hard Disk Drives
Removable Devices
ATAPI CD-ROM Drives
The submenu shown in Table 27 is for setting ATAPI CD-ROM drives.
Table 27. ATAPI CD-ROM Drives Submenu
Feature Options Description
1 st ATAPI CD-ROM Drive
(Note)
Dependent on installed
ATAPI CD-ROM drives Specifies the boot sequence from the available
ATAPI CD-ROM drives. To specify boot sequence:
1. Select the boot device with <
↑
> or <
↓
>.
2. Press to set the selection as the
intended boot device.
Note: This boot device submenu appears only if at least one boot device of this type is installed. This list will display
up to four ATAPI CD-ROM drives, the maximum number of ATAPI CD-ROM drives supported by the BIOS.
Exit Menu
Maintenance Main Advanced Security Power Boot Exit
The menu shown in Table 28 is used to exit the BIOS Setup program, saving changes, and loading
and saving defaults.
Table 28. Exit Menu
Feature Description
Exit Saving Changes Exits and saves the changes in CMOS SRAM.
Exit Discarding Changes Exits without saving any changes made in the BIOS Setup program.
Load Setup Defaults Loads the factory default values for all the Setup options.
Load Custom Defaults Loads the custom defaults for Setup options.
Save Custom Defaults Saves the current values as custom defaults. Normally, the BIOS reads the
Setup values from flash memory. If this memory is corrupted, the BIOS reads the
custom defaults. If no custom defaults are set, the BIOS reads the factory
defaults.
Discard Changes Discards changes without exiting Setup. The option values present when the
computer was turned on are used.