Impex MSS-1600 - Manual (Page 13)

A.) Attach two Ø 1” Bushings (#41) to the holes on Upper Frame (#4). Attach the Front Press Base
(#6) to the Bushings. Secure it with one M12 x 4 ½” Allen Bolt (#62), two Ø 1” Washers (#75), and
one M12 Aircraft Nut (#67). Do not over tighten the Nuts. Make sure the Front Press Base
can move freely.
B.) Attach the Left Butterfly (#7) to Front Press Base (#3). Secure it with one M12 x 4 3/8” Allen Bolt
(#63), two Ø 1” Washers (#75), and one M12 Aircraft Nut (#67). Repeat the Procedure to install
the Right Butterfly (#8).
C.) Attach the Swivel Pulley Bracket Frame (#15) to the back of the Vertical Frame (#3). Secure it
with one M10 x 2 ½” Allen Bolt (#68), two Ø ¾” Washers (#74), and one M10 Aircraft Nut (#76).
D.) Attach a Swivel Pulley Bracket (#12) to each end of Swivel Pulley Bracket Frame. Secure each
Bracket with one M10 x 2 ½” Allen Bolt (#68), two Ø ¾” Washers (#74), and one M10 Aircraft Nut
(#76). Do not over tighten the Nuts. Make sure the Swivel Pulley Brackets can move freely.
E.) Attach the Backrest Board (#25) to the Vertical Frame. Secure it with two M8 x 2 1/8” Allen Bolts
(#71) and Ø 5/8” Washers (#73).
12