Invacare 6027 - Manual (Page 5)

Part No 1141466 5 Walker Platform Attachment
Replacing Arm Pad
NOTE: For this procedure, refer to FIGURE 7.
NOTE: Note the position of the existing arm
pad for correct installation of the new arm pad.
1. Slip existing pad off of arm support.
2. Place new cover and pad on arm
support.
NOTE: The sides of the cover are on the outside
of the arm support, while the ends are tucked in.
FIGURE 7 Replacing Arm Pad
Replacing Fastening Strap
NOTE: For this procedure, refer to FIGURE 8.
1. Remove arm pad and cover. Refer to STEP 1 in Replacing Arm Pad on page 5.
NOTE: Note the orientation of the existing arm strap for installation of the new arm strap.
2. Pull on ring and remove fastening strap
through the slots in the arm support.
3. Thread the end, without the ring, of the
new arm strap through slots in the arm
support.
NOTE: Make sure the hook end is facing down
or the arm strap will not secure properly.
4. Reinstall the arm pad and cover. Refer to
STEP 2 in Replacing Arm Pad on page 5.
FIGURE 8 Replacing Fastening Strap
Storage
NOTE: The platform attachment does not require removal to fold the walker.
1. Fold the walker per your walker recommendations.
2. Lower the height of the platform attachments if necessary. Refer to Adjusting Height
on page 3.
Care and Maintenance
1. Use a mild soap or detergent to clean the arm pads and dry thoroughly.
2. A light oil may be applied to the hardware to lubricate and aid in preventing rust.
Arm
Pad
Arm
Support
Arm
Support
Fastening
Strap
Ring
Slots