Impex TC-3502 - Manual (Page 10)

7
STEP 4 (See Diagram 4)
A.) Attach the Backrest Pad (#12) to the Upper Vertical Frame (#1). Secure it with two M8 x 2 ¾”
Allen Bolts (#28) and
∅
5/8” Washers (#36).
B.) Attach the Arm Pads (#11) to the Left & Right Dip Supports (#7 & #8). Secure each Arm Pad
with two M8 x 2 ¾” Allen Bolts (#28) and Ø 5/8” Curved Washers (#39).
C.) Insert a Foam Tube (#10) halfway through the holes on the Lower Vertical Frame (#2). Push
two Foam Rolls (#24) onto the Tube from both ends. Plug two Foam Roll End Caps (#22) to the
end of the tube.
D.) Firmly thread each end of the Cable (#23) into the Upper and Lower Vertical Frames.
E.) Securely tighten all nuts and bolts pervious installed.