IBM Novell 10 SP1 EAL4 - Manual (Page 106)

•
0 The processor is not in hypervisor state.
•
1 If MSRPR= 0 the processor is in hypervisor state; otherwise, the processor is not in hypervisor
state.
The hypervisor takes the value of 1 for hypervisor mode and 0 for user and supervisor mode. The following
table describes the privilege state of the processor as determined by MSR [HV] and MSR [PR] as follows:
HV
PR Privilege State
0 0 privileged(supervisor mode)
0 1 problem (user mode)
1 0 privileged and hypervisor
1 1 Problem(user mode)
94