IBM 22P6415 - Manual (Page 32)

2. Click Add to add a new entry in the Excluded IP table.
v IP Address: Enter the specified IP address. The IP address must be
within the address pool of the DHCP server.
v Remark: The descriptions of the excluded IP address
3. Click Apply. A new entry is added to the Excluded IP table.
Note: The configuration changes made through the Web-based setup utility
are automatically saved into the flash memory within 30 seconds
after clicking Apply.
BOOTP IP Table
These are IP addresses reserved for the user using a BOOTP protocol to get an
IP address. The IP address must be within the address pool. To specify an IP
address to be used by the BOOTP protocol, do the following:
1. Click Advanced Configuration → DHCP Configuration → BOOTP IP to
display the BOOTP IP table.
5-4 IBM
®
High Rate Wireless LAN Gateway: User’s Guide