Intel D945GCLF2 - Manual (Page 50)

Intel Desktop Board D945GCLF2 Technical Product Specification
50
2.3 Jumper Block
CAUTION
Do not move the jumper with the power on. Always turn off the power and unplug the
power cord from the computer before changing a jumper setting. Otherwise, the
board could be damaged.
Figure 12 shows the location of the jumper block. The jumper determines the BIOS
Setup program’s mode. Table 21 lists the jumper settings for the three modes:
normal, configure, and recovery. When the jumper is set to configure mode and the
computer is powered-up, the BIOS compares the processor version and the microcode
version in the BIOS and reports if the two match.
Figure 12. Location of the Jumper Block
Table 21. BIOS Setup Configuration Jumper Settings
Function/Mode Jumper Setting Configuration
Normal 1-2
3 2 1
The BIOS uses current configuration information and
passwords for booting.
Configure 2-3
3 2 1
After the POST runs, Setup runs automatically. The
maintenance menu is displayed.
Recovery None
3 2 1
The BIOS attempts to recover the BIOS configuration. See
Section 3.7 for more information on BIOS recovery.