McIntosh MS300 - Manual (Page 16)

PAGE 12
MS300 User
’s Manual
SETUP
This manual assumes that you followed the printed “Quick Setup Guide” that came with your MS300. If you have
not properly connected your MS300 to your audio/video system, please go back and follow the “Quick Setup Guide”
before continuing with this User Manual.
POWER STATES
After the MS300 unit is plugged in, the Standby LED located next to the power button will flash red until the startup
process is complete. Please wait. This may take several minutes.
When the Standby LED is solid RED, the MS300 is now in a standby or “sleep” mode. There is no video output when
the MS300 is in standby mode. Press the Power button (on the front panel or on the remote) once and the video output
is displayed on your TV. The unit is now ON and the LED will be Off.
To change from the ON mode back to the standby or “sleep” mode, press the Power button on the front panel or on the
remote once. The video output will go blank and the LED will be solid red.
If power is removed from the MS300 for any reason, including a power outage or if the unit is unplugged, the MS300
will automatically return to the Standby state as soon as power is restored. When the MS300 is turned on again, the
MS300 will return to the same source mode that it was in when power was lost.
To force the MS300 to restart, PRESS and HOLD the Power button for 4 seconds, and release it when the standby
LED starts blinking.
When the Standby LED is RED and the MS300 has completed its startup process, press the
SETUP
Off = unit on