Multi-Tech Systems MT5634ZPX-PCI-V92 - Manual (Page 30)

4 AT Commands, S-Registers, and Result Codes
25
MultiModemZPX User Guide
Command: M n Monitor Speaker Mode
Values: n = 0, 1, 2, or 3
Default: 1
Description: M0 Speaker always off.
M1 Speaker on until carrier signal detected.
M2 Speaker always on when modem is off-hook.
M3 Speaker on until carrier is detected, except while dialing.
Command: N n Modulation Handshake
Values: n = 0 or 1
Default: 1
Description: N0 Modem performs handshake only at communication standard
specified by S37 and the B command.
N1 Modem begins handshake at communication standard speci-
fied by S37 and the B command. During handshake, fallback
to a lower speed can occur.
Command: O n Return Online to Data Mode
Values: 0, 1, 3
Default: None
Description: O0 Exits online command mode and returns to data mode (see
+++AT
escape sequence ).
O1 Issues a retrain and returns to online data mode.
O3 Issues a rate renegotiation and returns to data mode.
Command: P Pulse Dialing
Values: P, T
Default: T
Description: Configures the modem for pulse (non-touch-tone) dialing.
Dialed digits are pulsed until a T command or dial modifier is
received.
Command: Q n Result Codes Enable/Disable
Values: n = 0 or 1
Default: 0
Description: Q0 Enables result codes.
Q1 Disables result codes.
Q2 Returns an OK for backward compatibility with some software.
Command: S r=n Set Register Value
Values: r = S-register number; n varies
Default: None
Description: Sets the value of register Sr to the value of n, where n is entered
in decimal format. Example: S0=1.
Command: S r? Read Register Value
Values: r = S-register number
Default: None
Description: Reads the value of register Sr and displays it in 3-digit decimal
form. For example, S2? gives the response 043.