Milan Technology MIL-SM8002TG - Manual (Page 34)

26
learning states last before
the port begins forwarding.
Use the no form of this
command to return to the
default value.
stp-path-priority [Port
Priority]
Interface
configuration mode
Use the spanning-tree
port-priority interface
configuration command to
configure a port priority that
is used when two switches
tie for position as the root
switch. Use the no form of
this command to return to the
default value.
128
Switch (config)# interface
fastEthernet 0/2
Switch (config-if)#
stp-path-priority 127
QOS Commands Set
Commands Command Level Description Defaults Example
qos storm-control
[5|10|15|20|25| off (%)]
or no storm-control
Global
configuration mode
Enable/Disable broadcast
storm control. Use the no form
of this command to restore to
default.
OFF
Switch (config)# qos
storm-control 5
qos
low-priority-delay-bound
[on|off] [sec.] or no qos
low-priority-delay-bound
Global
configuration mode
Enable/Disable low priority
delay board.
Use the no form of this
command to restore to default.
OFF
Switch (config)# qos
low-priority-delay-bound on
1
qos level [priority]
enable
Global
configuration mode
[Priority] 0~7
0~3 LOW
4~7 HI
Switch (config)# qos level
2,3 enable