beautypg.com

Connecting with other equipment, Monitor to be connected, Monitor – MITSUBISHI ELECTRIC HS-S8300E(BRS) User Manual

Page 7: Sensor, Cctv camera

background image

7

CONNECTING WITH OTHER EQUIPMENT

AUDIO
OUT

MIC IN

VIDEO
OUT

VIDEO IN

AUDIO IN

MONITOR

SET IN

SENSOR

VIDEO
OUT

CCTV
CAMERA

VIDEO

IN

MIC

VIDEO

OUT

IN

IN

OUT

MIC

AUDIO

RESET

REMOTE

SET

RST

IN

REC

GND ALM MODE

CLK CALL

OUT

IN

OUT

S-VIDEO

OUT

IN

RS-232C

VERTICAL ADJUSTMENT (Correcting picture vibration at the top and bottom)

The picture vibration can be reduced or eliminated by the following steps.

1

If the vibration occurs in still, slow motion, fast playback (x2) or normal playback in 12H - 960H or 0H mode,
playback a tape which is recorded in 3H mode with this VCR and press the PAUSE button.
If the vibration occurs during normal playback in L12H or L24H mode, playback a tape in each playback mode.

2

Press the VERTICAL ADJUST (+) or (-) button to reduce or eliminate the picture vibration.

N

When QUASI V-SYNC is set to “OFF”, the picture vibration is not adjustable with the VERTICAL ADJUST buttons.

MONITOR TO BE CONNECTED

Connection with a CCTV monitor (for surveillance) is recommended.

Connecting with some monitors may cause picture vibration and/or picture distortion at the top or bottom of the image
during still or normal playback.
A domestic Television used as a Monitor may be unable to provide a stable picture without vibration and distortion.