Siemens CF62 - Manual (Page 70)

©
Siem
ens AG
2003, I
:\Mob
il\R6
5\CF62_Le
op
ar
d_
ab
gel._v
on
M
C60_M
aguro
\e
n\_v
on
_i
tl\fug\
CF62
_fug_en_040422\A65_
Setup
.f
m
69 Setup
VAR Langua
ge: English; VA
R issue
da
te
: 1
0-Fe
bruar
-2004
right page (69) of CF62 Leopard en, A31008-H6050-A1-1-7619 (28.04.2004, 11:45)
Call setup
§Menu§
KmK
Call setup
K
Select function.
Hide ID b
When you make a call, your phone
number can be displayed on the
recipient's display (depending on
the service providers).
To suppress this display, you can
enable the "Hide ID" mode for all sub-
sequent calls or just for the next call.
You may need to register separately
with your service provider for these
functions.
Call waiting b
If you are registered for this service,
you can check whether it is set and
you can activate/deactivate it (see
also page 22).
Divert
You can specify when calls should
be diverted to your mailbox or other
numbers.
Set up call divert (example):
The most common condition for call
divert is, for example:
All Unanswered
b
I
Select All Unanswered .
(Includes the conditions
Not reachable , No reply ,
Busy , see below)
E
Press.
Set Select.
J
Enter the phone number
to which the caller will
be diverted (If not already
entered)
Or
·
Select this phone number
from the Addressbook/
Phonebook or via §Mailbox§ .
§OK§ Confirm. After a short
pause, the setting is con-
firmed by the network.
All calls
b
All calls are diverted.
n
Symbol in the top line of
the display in standby
mode.
Not reachable
Divert occurs if phone is switched off
or is out of range.