Spdif output 37 – Philips Magnavox MDV455 User Manual

Page 37

If you connected the DVD Player to a Stereo using the COAXIAL jack as
shown on page 15, you need to adjust the SPDIF OUTPUT (digital audio)
setting as described below. If you are not using the COAXIAL jack, no
adjustment is necessary.

Press SYSTEM MENU.

The General Setup Page will be selected. Press OK or 4.

Press 4 repeatedly to select SPDIF Output, then press 2.

Press 3 or 4 to select SPDIF Off, SPDIF/RAW, PCM/48K or
PCM/96K, then press OK.
Choose SPDIF/RAW to select the original default audio settings as
received by most Stereos. However, if the sound is distorted, your
Stereo may need to receive audio in the PCM format (pulse code
modulation, contains only left and right audio signals).
Discs are recorded in a certain sampling rate.The higher the sampling
rate,the better the sound quality. Some Discs are recorded in a high
sampling rate of 96KHz. Select PCM/96K if you are playing Discs
recorded at this high rate. Otherwise, select PCM/48K.
Choose PCM/48K or PCM/96K only if your Stereo is PCM-
compatible. Or, if your Stereo cannot decode MPEG-2 or DTS audio,
choose SPDIF/RAW.
Refer to your Stereo owner’s manual for details.

Press SYSTEM MENU to remove the menus.

SPDIF Output 37

1,5

2-4

- - General Setup Page - -

RAW Data Via SPDIF

TV Display

Angle Mark

OSD Lang

SPDIF Output

SPDIF Off

Captions

SPDIF/RAW

Program

PCM/48K

Screen Saver

PCM/96K

• SPDIF is the Sony-Philips Digital

Interface.

Helpful Hint

MDV455_17x 11/11/03 4:34 PM Page 37