Midland Radio WR-300 - Manual (Page 21)

20
pattern, press and release “MENU” button. Press the UP or
DOWN arrow button until “ALERT MODE ” is displayed in the
left side of the display. Press and release the “SELECT” button
then “UP or DOWN arrows” to display the choice of alert pattern.
Press and release the “SELECT” button to keep that pattern and
continue with programming. Press and release the “MENU”
button to return the radio to alert mode.
NOTE: Remember if there are no buttons pressed for one minute
the WR-300 will exit menu mode.
Voice and siren alerts can be turned off for all events leaving only
the text message and LED light to indicate the event. Press and
hold the ALERT ON/OFF button for 5 seconds to see the display
“ALERT ON(0FF)". While continuing to hold the ALERT
ON/OFF button, press the up or down arrow key to change the
setting. Release the buttons then press the ENTER key to
confirm.
FIPS Code programming:
NOTE: The WR-300 has enough memory to store 30 “FIPS”
codes. To store or change the codes, press and release “MENU”
button. Press the UP or DOWN arrow button until “COUNTY
CODE ” is displayed in the left side of the display. Press and
release the “SELECT” button then “UP or DOWN arrows to
choose from three options in how your radio responds to the
county (FIPS) codes is receives. Choose “SINGLE” if you want
to hear only alerts sent to one county or FIPS code. Choose
“MULTIPLE” if you want to hear alerts from all FIPS codes you
have programmed. Select “ALL” to listen to all alerts your
station sends without regard to FIPS codes. If you chose