Multi-Tech Systems MVP200 - Manual (Page 9)

9
Cabling
Cabling Your MultiVOIP
Cabling your MultiVOIP involves making the proper Power,
Command Port, phone system, and Internet connections.
Figure 3 shows the back panel connectors and the associated
cable connections. The following procedure details the steps
necessary for cabling your MultiVOIP.
Before starting to cable your MultiVOIP, perform the E&M
Jumper Block Positioning Procedure, which immediately
follows the Cabling Procedure, if either voice/fax channel (1 or
2) will be connected to an E&M trunk that is a Type 1, 3 ,4, or
5 rather than a Type 2 (the default).
1. Connect the power supply to a live AC outlet, then connect
it to the MultiVOIP as shown in Figure 3. The power
connector is a 6-pin circular DIN connector.
Voice/Fax Channel
1 & 2 Connections
Network Connection
Power Connection
FXS E&M FXO
PSTN
Command Port Connection
Hub
PBX
Voice/Fax Channel 1
E&M FXS FXO
Voice/Fax Channel 2
FXO FXS E&M
1
0
Power
Ethernet RS232
Command 10Base-T
Figure 3. Cable Connections
2. Connect the MultiVOIP to a PC using the RJ-45 to DB9
(female) cable provided with your unit. Plug the RJ-45 end
of the cable into the Command port of the MultiVOIP and
connect the other end to the PC serial port you are using.
See Figure 3.