MicroBoards Technology CWT Series - Manual (Page 8)

CWT Series MICROBOARDS TECHNOLOGY, LLC
8
DISC ERASE?
(REWRITABLE)
QUICK ERASE?
FULL ERASE?
SURE?
DISC ERASE
3. Place the blank disc(s) into the Recorder drive(s) and wait 10 seconds for the light(s) on
the front of the Recorder(s) to stop blinking.
4. Press YES.
5. The drive trays will open on any recorder without blank discs installed. If you do not want
to make a copy in those drives, close the tray(s), wait for the drive light to go out, and
then press the YES button to start the copy job.
6. The display will now show the progress of the Simulation Copy Job
7. The Recorder(s) will eject the still-blank discs when the job is complete.
Erasing RW media
1. At the COPY START? (DISC to DISC) menu, press the NO or ▼ button until the display
shows DISC ERASE? (REWRITABLE):
2. Load the Recorder(s) with the CD-RW media you wish to erase. You can erase one disc
at a time or fill all the Recorders to erase multiple discs at once. All discs loaded must be
of the same type.
3. Press the YES button
4. The next screen asks if you want to perform a Quick Erase.
If you wish to perform a Full Erase, press the NO button.
Pressing the YES button at either of these selections will show the following screen:
5. Press the YES button if you are sure you want to erase the RW disc. If you do not wish
to erase the disc, press the NO button and you will go back to the DISC ERASE screen
(step 1).
6. The screen will now show:
7. Once the erasing is complete, the Recorder(s) will eject the disc(s).
SIMULATION 425.0MB
CD 25%