MicroBoards Technology CWT Series - Manual (Page 10)

CWT Series MICROBOARDS TECHNOLOGY, LLC
10
Setup Menu
1. At the COPY START? (DISC to DISC) menu, press the NO or ▼ button until the display
shows SETUP? (MODE CHANGE)
SETUP?
(MODE CHANGE)
2. Press the YES button
3. The first setup option is Mode Select, followed by Write Speeds, ISRC Check, Copy
Quantity, Session Mode, Drive Inquiry, Firmware Version and Exit.
4. Pressing the NO or ▼ button will allow you to move from menu to menu.
5. Pressing the YES button will allow you to view or change the configuration of the system.
6. Please follow the flow chart on page 9 to navigate through the different menus.
Here is a description of each setup menu item:
Mode Select
COPY - Duplication from master disc to blank disc.
VERIFY - It compares a copied disc with the master disc.
COPY+V - Copying in the COPY+VERIFY mode
CD WR Speed
Available speeds range from 52x down to 4x.
ISRC Check
Default setting is ON. This feature will copy the ISRC codes from the Master audio disc to the
blank discs.
Auto Run
Default setting is OFF. When set to ON, this allows the duplicator to start the duplication process
when all recorders are loaded with blank media. The master must also be loaded before
duplication will begin.
Copy Quantity
Set up the number of disc you want to copy.
Use the ▼▲buttons to change the number in the current column up or down. YES will move you
one column to the right, NO will move you 1 column to the left. Press YES when in the right
column to save the number of copies entered. The example above shows that 750 copies have
been entered with the cursor currently in the right column (underlined).
Session Mode
Select either from AUTO, CLOSE, or OPEN.
AUTO: Make the session of copied disc as same as the master.
CLOSE: Close the session of copied disc.
OPEN: Leave the session of copied disc open.
Reader Select
Changes which drive is selected as the reader. This setting should not be changed.
Drive Inquiry
Displays an inquiry of each drive connected, showing drive model and firmware.
F/W Version
Shows CWT Series firmware version and H/W information.
F/W Update
Used when updating the firmware of the CWT Series duplicator.
Log
Displays the number of successful and unsuccessful discs over the entire life of the duplicator.
>>COPY QUANTITY
0750