MITSUBISHI ELECTRIC G-50A - Manual (Page 14)

-12-
19 30 ˚C / 67 87 ˚F
17 28 ˚C / 63 83 ˚F
19 28 ˚C / 67 83 ˚F
4 - 2 Operation setting
4 - 2 - 1 Group operation setting
• There are two methods for the operation, performing the operation classified by groups or collective operation.
No. Name of switches Function Display
Ventilation
Operation status display
*When there is an interlocked OA processing unit
ON/OFF switch
The ON/OFF condition of the dis-
played group is switched.
Operation mode
switch
Fan speed
switch
Temperature
setting switch
or LOSSNAY , turning this switch ON starts
operation in a [High] ventilated state.
Each time to push the switch, a mode is selected in
Used to the type of the operation
mode selection.
Note:
Operation mode can be selected ac-
cording to the function of unit.
If the unit is only cooling type.
HEAT/AUTO mode may not appear
on the display.
Refer to the instruction manual of
the air conditioner for more detail.
The fan speed can be switched to four
On the group composed of independent LOSSNAY ,
operation mode is selected in a sequence that goes
from HEAT RECOVERY,AUTO, BY-PASS and back
to HEAT RECOVERY.
4 levels
2 levels
The setting temperature display.
The setting range change according to the operation
mode.
COOL/DRY
HEAT
AUTO
Fan speed display
a sequence that goes from COOL, DRY, FUN,
AUTO, HEAT and beck to AUTO for air conditioner
group.
levels. Switching may be 3 levels or 2
levels, depending on the model.
The setting temperature change is per-
formed.
3 levels
NOTE: The temperature setting includes a function
to switch the display between Celsius (
°C)
or Fahrenheit (
°F) (page 34).
1
2
3
4